![hyperterminal commands list hyperterminal commands list](https://res.cloudinary.com/practicaldev/image/fetch/s--lz2Zpv6h--/c_limit%2Cf_auto%2Cfl_progressive%2Cq_auto%2Cw_880/https://thepracticaldev.s3.amazonaws.com/i/z5llkcoy2pjfnux1kk5h.png)
#HYPERTERMINAL COMMANDS LIST INSTALL#
You will be given a much more restricted list of command possibilities that address the possible interfaces to be set.įor a complete list of command line interface commands, refer to the "Avaya P330 ManagerUser's Guide".ĭetermine Necessary Firmware to Install on the G700 You will be given the current list of set commands available. To check the syntax of a command in the command line interface, type as much of the command as you know followed by help. The prompt appears as P330-1(configure)#. In order to use the commands necessary to configure the P330 Stack Processor (Layer 2 Switching Processor), you must reset to the Configure level. You are now logged-in at the Supervisor level.
![hyperterminal commands list hyperterminal commands list](https://i.ytimg.com/vi/1Fmp8bH0jPw/maxresdefault.jpg)
Password: xxx from the planning documentation Login: xxx from the planning documentation
![hyperterminal commands list hyperterminal commands list](https://docs.tibbo.com/soism/an008_screen1.jpg)
#HYPERTERMINAL COMMANDS LIST SERIAL#
Connect the other end of the DB-9 adapter cable to the 9-pin serial port on your laptop.Plug the other end of the RS-232 cable into the RJ-45 jack on the DB-9 adapter cable.The name of the serial port varies on P330 devices, but it is located on the lower right.On a G700, this serial port is labeled Console.The serial port is on the lower right side of the chassis. Attach one end of the RS-232 cable to the RJ-45 jack on the front of the unit that is the stack master.Use the RS-232 serial cable and DB-9 adapter cable provided with the G700 Media Gateway.P330 device: a lit SYS LED indicates that this unit is the stack master.G700 Media Gateway: a lit MSTR LED indicates that this unit is the stack master.Check the LED panel on the upper left of each G700 or P330 device in the stack as follows: For a stacked configuration: locate the device that contains the master controller for the stack.To connect a laptop directly to the serial port on the G700 Media Gateway: If the versions do not match, new firmware for those components is necessary.Ĭonnect Your Laptop to the G700 Serial Port Conduct the following procedure in order to compare software versions running on the G700/Media Modules with the Release Letter.